The primary things the do-it-yourselfer realizes when learning building a drywall ceiling is the fact that no man is definitely an island – unless he uses rented equipment! As the panels are big, bulky, and awkward, hanging drywall with a ceiling entails either: the help of another individual or renting a drywall jack from a local home improvement center. The cable mechanism on drywall jacks is not difficult to operate, and jacks do an outstanding job of holding the drywall in the secure, flat position assisting you to more easily attach it for the ceiling.

Tools & Materials

Developing a Drywall Installation Video includes understanding what all tools and material you will want. Together with either another individual that will help you or a drywall jack, you will also need a hammer, a drill with a screwdriver bit, and nails or screws for drywall. You’ll also, naturally, should measure your ceiling (twice!) and purchase enough drywall, including a little extra in case there is mistakes, to do the job.

Mark Joists First

Find the boards – usually 2x4s or 2x6s – that be ceiling joists by tapping down the wall studs with a hammer and following in the wall for the ceiling. As part of learning to build a drywall ceiling, mark where these boards are situated with a pencil. These are generally what will you be attaching the drywall to and marking them beforehand makes it quicker to find them than searching for them while nailing or screwing on the drywall. You then should measure where the permanent fixture proceeds the drywall and remove a hole to support that section of the ceiling.

The Tough Part

Now’s the part in learning building a drywall ceiling where you will want each other (who hopefully has lots of stamina in addition to strength!) to support the drywall to the ceiling or to position the drywall panel on the jack. Set the end of the sheet of drywall – using its finished side facing down – in the center of the ceiling board (joist) which you are going to nail it. Nail around the outside of the panel about a one-half inch from the edges to prevent the drywall from splitting or cracking. The individual that is holding the panel is now able to move or, if you are by using a jack, you’ll be able to move it out of how.

Help it become Pretty

Countersink nails or screws at six- or seven-inch intervals all down the entire joist which the drywall has been attached. Countersinking enables you to cover up the heads of the nails/screws with compound so that when you paint, the heads will not be whatsoever visible. Although not a legitimate portion of understanding how to construct a drywall ceiling, learning to cover up ugly nail or screw heads serves its purpose for overall general carpentry knowledge.
Check out about Drywall Installation Video browse this useful webpage: click for info