The primary things the do-it-yourselfer realizes while studying how to build a drywall ceiling is the fact that no man is surely an island – unless he makes use of rented equipment! For the reason that panels are big, bulky, and awkward, hanging drywall on the ceiling entails one or other: the help of another person or renting a drywall jack from your local hardware store. The cable mechanism on drywall jacks is just not difficult to operate, and jacks do a fantastic job of holding the drywall in the secure, flat position assisting you to more easily attach it on the ceiling.
Tools & Materials
Developing a Basement Drywall Installation includes understanding what all tools and material you may need. Together with either another person to assist you or perhaps a drywall jack, included in the package require a hammer, a drill with a screwdriver bit, and nails or screws for drywall. You’ll also, obviously, must measure your ceiling (twice!) and buy enough drywall, such as a little extra in the case of mistakes, to do the job.
Mark Joists First
Obtain the boards – usually 2x4s or 2x6s – that function as ceiling joists by tapping down the wall studs with a hammer and following up the wall on the ceiling. Included in figuring out how to develop a drywall ceiling, mark where these boards are situated with a pencil. These are what you would be attaching the drywall to and marking them beforehand can make it quicker to locate them than attempting to find them while nailing or screwing around the drywall. Then you definately must measure the place that the fitting goes on the drywall and reduce a hole to support that area of the ceiling.
The hard Part
It’s part in learning how to build a drywall ceiling where you may need the other person (who hopefully has plenty of stamina in addition to strength!) to keep the drywall up to the ceiling or squeeze drywall panel around the jack. Squeeze end in the sheet of drywall – having its finished side facing down – in the center in the ceiling board (joist) that you are likely to nail it. Nail around the outside of the panel of a less than an inch from your edges to stop the drywall from splitting or cracking. The person who is holding the panel can now move or, in case you are by using a jack, it is possible to move it of the way.
Help it become Pretty
Countersink nails or screws at six- or seven-inch intervals all down the length of the joist that the drywall has become attached. Countersinking lets you conceal the heads in the nails/screws with compound so that once you paint, the heads will not whatsoever visible. While not the best part of focusing on how to create a drywall ceiling, figuring out how to conceal ugly nail or screw heads serves its purpose for overall general carpentry knowledge.
Check out about Basement Drywall Installation check this useful web page: read this