Carbide burs are among the most widely used and versatile cutting tools found in virtually every industry. Produced from Tungsten Carbide they may be primarily used to remove burrs (the small flakes of metal) that usually remain on the project piece following your machining process. Burs are available in standard lengths long series (for hard to reach applications) and in miniature sizes (to be used in pencil grinders).


Features
Solid carbide tools offer long tool life and faster cutting speeds than other substrates, however are more brittle and should be utilized with rigid tool holding systems
Uncoated tools feature exactly the base substrate without any additional treatment or coatings and are suited to a wide range of applications
Round shanks allow use with a wide variety of tool holding systems
Double-cut style has rows of cutting teeth decline in two intersecting directions for fast material removal plus a rougher finish
For deburring, interior contour work

CUT TYPE

Singlecut
General purpose tool for certain, copper, brass and steels
Fairly aggressive cutting action, with good material removal rates
It leaves a good finish of many all materials, however the bite might be demanding on operators

Doublecut
For general purpose use including cast iron, copper, brass and steels
The Doublecut works with a cross flute of exactly half the volume of standard flutes inside a opposing helix
Sliver size is greatly reduced, as they are the operator fatigue from your balanced cutting forces
Lower RPMs could possibly be utilized with little negative influence on performance
The decreased load compatible operator’s often feeding it more aggressively

Alumacut
Best for all non-ferrous, non-metallic workpieces like aluminum, zinc, plastic, wood, etc.
An extremely aggressive cutting action, with no probability of plugging these flutes up

Diamondcut
Is often a finer cut of opposing helixes
Operating control is superb as the biting action is restricted out of the box the silver size manufactured from it
This version is usually preferred to acquire where titanium and other difficult materials (superalloys) are being deburred
With all the teeth being smaller and more fragile therefore, tool every day life is not often a couple of import

Fiberglass will cut nicely with Diamondcut

Chipbreaker
Another version of the Doublecut, it is a slightly less aggressive tool whose main purpose would be to simply interupt the cut

One, opposing helix is ground inside a spiral across the tool, typically
Silver size falls, surface finish falls marginally, hand control climbs up, marginally
For more info about https://www.burrs4less.com/sa-9-31.html explore the best website

Leave a Reply