Carbide burrs are tools used for deburring most hard materials like ceramics, stone, steel, aluminum, plastics and hardwood. They provide precision, which enable it to also be employed in cutting, shaping, grinding and chamfering hard materials.

Carbide burrs can be used with a variety of materials like metals (including Steel aluminum and surefire) and all kinds of wood. Quite a few on acrylics, fiberglass and plastics too. Carbide burrs will last for quite a long time without chipping or breaking in order that it’s so competent to utilize them on soft metals like gold,platinum and silver.

What Are The Attributes of Carbide Burrs Compared with HSS Burrs?

Compared with HSS, Carbide Burrs less difficult harder.

The Tungsten Carbide is very hard so that they can be utilized in wider array of work than HSS (Broadband Steel).

HSS can’t perform as well as carbide burrs when they’re at temperature. Carbide Burrs can bear hotness and can run for extended time.

Carbide won’t soften at warm but HSS burrs is opposite. No doubt that carbide is the perfect choice.

Utilizing Carbide Burs:

For additional stability, insert the accessory bit into the oral appliance then back it slightly before tightening down the collet nut or keyless chuck.

Don’t use these for drilling holes or enlarging holes which might be below twice the diameter from the cutter. The tungsten carbide surface can simply catch the side of a hole and break the bit.

Use higher speeds for hardwoods, slower speeds for metals and slow speeds for plastics (to prevent melting at contact point).

Start at a lower speed. Then increase on the speed which gives one of the most favourable results.

Do not apply excessive pressure. It can slow up the spindle and chip cutting edges. Just let the bur do the cutting.

Make use of the sides from the cutter for effective cutting. The top cuts poorly which enable it to break pressurized.

Never in-capsulate the bur from the cut. If chattering occurs, increase speed.

When you use aluminium and magnesium, consider some sort of lubricant, wax or tallow, since it may help avoid the flutes from loading or packing.

Carbide burs, if used the correct way, will outperform HSS burs by 50
For details about SD-51 Carbide Burrs check the best web site