One of the primary things the do-it-yourselfer realizes while studying how to construct a drywall ceiling is that no man is an island – unless he uses rented equipment! For the reason that panels are big, bulky, and awkward, hanging drywall on the ceiling entails one or the other: the aid of another person or renting a drywall jack from a local home improvement center. The cable mechanism on drywall jacks is not difficult to operate, and jacks do an excellent job of holding the drywall inside a secure, flat position assisting you to with less effort attach it for the ceiling.


Tools & Materials

Developing a Drywall Installation diy includes being aware of what all tools and material you will want. In addition to either another person that will help you or even a drywall jack, you’ll also need to have a hammer, a drill having a screwdriver bit, and nails or screws for drywall. You can also, obviously, must measure your ceiling (twice!) and buying enough drywall, including a little extra in case of mistakes, for the job.

Mark Joists First

Find the boards – usually 2x4s or 2x6s – that work as ceiling joists by tapping along the wall studs having a hammer and following in the wall for the ceiling. In finding out how to make a drywall ceiling, mark where these boards are located having a pencil. They are what will you be attaching the drywall to and marking them beforehand helps it be quicker to find them than attempting to find them since you are nailing or screwing around the drywall. Then you definately must measure the location where the bulb continues the drywall and cut out a hole to allow for that section of the ceiling.

The hard Part

Its part in mastering how to construct a drywall ceiling where you will want the other person (who hopefully has a good amount of stamina along with strength!) to carry the drywall up to the ceiling or to place the drywall panel around the jack. Placed the end from the sheet of drywall – having its finished side facing down – in the center from the ceiling board (joist) to which you will nail it. Nail throughout the away from the panel with regards to a one-half inch through the edges in order to avoid the drywall from splitting or cracking. The individual that is holding the panel is now able to move or, should you be using a jack, it is possible to move it of how.

Help it become Pretty

Countersink nails or screws at six- or seven-inch intervals all along the entire joist to which the drywall has become attached. Countersinking permits you to mask the heads from the nails/screws with compound to ensure that whenever you paint, the heads will not in any way visible. Although not the best section of finding out how to build a drywall ceiling, finding out how to mask ugly nail or screw heads serves a unique purpose for overall general carpentry knowledge.
To learn more about Drywall Installation diy browse this useful webpage: look at more info

Leave a Reply